Interior window sealing tape
For detailed information, other images and documents, please select individual articles from the following table.
Available in 2 versions
Prices for customers after login
Exclusively for trade customers
Register now and access more than 40,000 products
Variants
Exclusively for trade customers
Register now and access more than 40,000 products
Full-surface, adhesive window sealing tape for quick and simple sealing of indoor joints. The window sealing tape consists of a non-woven composite material with a functional film and laminated, acrylic-based self-adhesive strip and alternating full-surface adhesive finish for fastening to the window profile and masonry.
Application area:
The window sealing tape is especially suitable for the inner sealing of the window connection joint between the window frame and masonry.
Advantages:
Vapour impermeable
Offers maximum protection against indoor air pollution - certified in accordance with GEV-EMICODE® EC1PLUS - very low emissions
Superb results when plastered or painted over
Split foil liner for easy handling
Adheres excellently to many surfaces that are commonly used in construction
Extremely supple on slightly uneven substrates
Design:
Self-adhesive surface/full self-adhesive surface
Advice:
Application:
The adhesive surfaces must be load-bearing and stable. The surfaces must be free from dust, release agents, oil, grease, moisture and ice.
When sealing house door and window connections, the release paper is removed from the self-adhesive strip of the window sealing tape, applied to the window frame and firmly pressed down or rolled on.
The window sealing tape can then be adhered to the wall material and rolled on. It is best to press the tape down using a press-on roller (0693 603 002) to ensure proper adhesion.
The window sealing tape can be pre-applied in the workshop. Due to the one-sided, full-surface self-adhesive, no additional bonding with an MS polymer adhesive is required.
The tape must always be installed without tension. Film overlaps must be at least 50 mm in width. The minimum adhesive surface on the component is 30 mm. For vertical joints, always glue the upper tape over the lower tape.
It is advisable to first carry out an adhesion and compatibility test on each surface. If necessary, pre-treat the surface with a spray primer (0894 800 500). Non-tight areas, corners and cavities are bonded with S78 bond and seal (0898 511 4).
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!