Injectable mortar VM-EA

The universal injection system for non-cracked concrete, damp concrete, water-filled boreholes and masonry made from solid or perforated brick.

The VM-EA injection system is an injection system for fixtures in non-cracked concrete and masonry. The system includes an epoxy acrylate-based, styrene-free chemical injection mortar in a mortar cartridge, as well as a VMU-A anchor rod, V-A or commercially available threaded rod with acceptance test certificate 3.1 (e.g. VM-A), as well as a nut and washer. When used in perforated brick, a perforated sleeve is also required.

Field of Application:

For anchorages in non-cracked concrete such as base plates, supports and wall brackets and for mounting joint tapes.

Anchoring in masonry:
Canopies, door and window frames, facade substructures, battens, gates etc.

Advantages:

Versatile injection system for different applications in concrete and masonry
Approved for non-cracked concrete
Approved for installation in damp concrete and in water-filled drill holes
Approved for aerated concrete and solid and perforated brick masonry; dry or wet
Approved with anchor rods and for commercially available threaded rods with proven strength (acceptance test certificate 3.1)
Approved with adjustable push-through perforated sleeve VM-SH 16 x 130/330 for bridging insulation systems and other soft
surfaces
Substrate temperature during application: -5°C to +40°C
Ambient temperature after full curing: -40°C to +80°C
Variable anchoring depths for added flexibility
Opened cartridges can continue to be used with a new mixer nozzle
Styrene free

Advice:

Perforated sleeve VM-SH 16 x 130/330 enables fixtures in perforated brick through insulation boards.
The tubular film cartridge (0911 005 300) must be cut open before use. To do this, pull the foil on the thread outwards and cut using scissors.