In-front-of-wall installation flex adhesive WF

High-quality, neutral, single-component and permanently flexible adhesive and sealant based on hybrid polymers. Flex adhesive WF is specially designed for bonding and sealing the in-front-of-wall installation system WF.

Application area:

Flex adhesive WF is used for tension-free bonding of the in-front-of-wall installation system WF and for sealing and bonding applications in corner joints and to the wall material.

Flex adhesive WF adheres excellently, usually without primer, to a wide range of surfaces, such as autoclaved aerated concrete, sand-lime brick, vertically perforated brick, polystyrene, concrete and wood. The adhesive surface must be load-bearing, clean and free of dust and grease. Dry surfaces are especially suitable, although flex adhesive WF also adheres to moist surfaces. Porous surfaces with a highwater load should be pre-treated with RECA spray primer (0894 800 500) if necessary.

Advantages:

High initial adhesion
Very good processing
Permanently flexible after curing
Waterproof and non-corrosive
Excellent adhesion, usually without primer, to almost all (even moist) surfaces
Compensates unevenness and material tensions
Blister-free curing even at high temperatures
Easily painted over, colour-fast, weather and UV resistant
Free of silicone, solvents, halogens, acids and isocyanate
Certified in accordance with GEV-EMICODE® EC-1 plus - very low emissions

Advice:

Cures via humidity at room temperature. Curing is much slower at low temperatures and/or low humidity.
For bonding and sealing of the in-front-of-wall installation system, please observe the notes in the installation instructions.